This motion detector (PIR = passive infrared receiver) detects the presence of a person in a room. The units send information to a controller or any other associated Z-Wave device. Up to 4 devices can be controlled from this device. Beside the motion detector function the device also works as temperature sensor. The installation can be done with screws or double-sided tape. The device is battery-operated and therefore in sleeping mode unless an action is detected. After a programmable sleeping time the device wakes up and sends a status information. After this the unit goes back to sleeping modus. Batteries can be changed without unscrewing the device. The unit will give a visual warning on the device and sends a warning to the Z-Wave controller, when batteries need to be replaced. A tamper switch protects the device from removal or manipulation if used in security applications. The powerful CR123 Lithium battery lasts 3 ... 5 years on normal operation conditions. The device supports normal Z-Wave inclusion, auto inclusion and network wide inclusion for convenient handling. Scope of delivery includes the device itself, the battery, adhesive tape and an instruction manual. When included securely the device is able to accept secure commands and to send secure commands to other devices. The commands and the receiver of the commands sent out on single click and on double click of the rocker can be defined in configuration parameters and association groups.